Home › Vehicle Exterior › BODY WELD POINT › ROCKER OUTER PANEL
BM3210E _01 Vehicle Exterior _050433 BODY WELD POINT _0251821 ROCKER OUTER PANEL F

BODY WELD POINT  ROCKER OUTER PANEL  CUT AND JOIN REPLACEMENT SECTIONS  


K131457

REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108827

Cut and Join Location
K108828

Cut Location for Supply Parts

K131554C01
3.021,3 3.333,3.156 0.313,0.156 10 false *a
*a 475 mm (18.70 in.) - -
K111603

Laser Screw Welding - -


K131555

a.

When replace only the outer panel, please cut off a necessary range depending on a damage range.

i.

Carefully cut the outer panel so not to damage the reinforcement.


ii.

Make sure that butt welding does not heat-affect the reinforcement when welding the outer panel.




INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108831

Butt Weld

a.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.


b.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

K131556C01
2.75,4.667 2.583,4.667 2.583,4.667 2.5,3.896 false 2.771,4.583 3.083,4.74 0.313,0.156 10 false *1
*1 CENTER BODY PILLAR OUTER - -
K111603

Laser Screw Welding - -



c.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


d.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.