HANDLING OF A VEHICLE THAT HAS BEEN DAMAGED IN A COLLISION
Refer to the TOYOTA Repair Manual for the SRS airbag system inspection procedures.
If impacts are likely to occur to the front airbag sensors, door side airbag sensors, side airbag sensor assemblies, side No. 2 airbag sensor assemblies, rear airbag sensors, or airbag ECU assembly remove each sensor as necessary beforehand.
Do not allow the front airbag sensors, door side airbag sensors, side airbag sensor assemblies, side No. 2 airbag sensor assemblies, rear airbag sensors, or airbag ECU assembly to become heated to high temperatures.
Check the wire harnesses and connectors for damage and/or melting, as some areas of the airbags and seat belt pretensioners may heat up to several hundred degrees when they operate.
PRECAUTIONS FOR USING ELECTRIC WELDER
Check the Diagnostic Trouble Codes (DTCs).
If one or more DTCs are displayed:
Disconnect the negative (-) terminal cable from the battery.
Disconnect all the malfunctioning circuit connectors.
Disconnect the airbag ECU assembly connector.
If DTCs are NOT displayed:
Inspect for damage to the electric wiring harnesses and connectors.
Disconnect the negative (-) terminal cable from the battery.
Disconnect the airbag ECU assembly connector.
PARTS LOCATION
| *1 | FRONT AIRBAG SENSOR LH | *2 | FRONT AIRBAG SENSOR RH |
| *3 | DOOR SIDE AIRBAG SENSOR LH | *4 | DOOR SIDE AIRBAG SENSOR RH |
| *5 | SIDE AIRBAG SENSOR ASSEMBLY LH | *6 | SIDE AIRBAG SENSOR ASSEMBLY RH |
| *7 | SIDE NO. 2 AIRBAG SENSOR ASSEMBLY LH (w/ Airbag Cut Off Switch) | *8 | SIDE NO. 2 AIRBAG SENSOR ASSEMBLY RH (w/ Airbag Cut Off Switch) |
| *9 | REAR AIRBAG SENSOR LH | *10 | REAR AIRBAG SENSOR RH |
| *11 | CURTAIN SHIELD AIRBAG ASSEMBLY LH | *12 | CURTAIN SHIELD AIRBAG ASSEMBLY RH |
| *13 | REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH (w/ Rear Pretensioner) | *14 | REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH (w/ Rear Pretensioner) |
| *A | for LHD | - | - |
| *1 | HORN BUTTON ASSEMBLY | *2 | INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY |
| *3 | LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY | *4 | FRONT SEAT CUSHION AIRBAG ASSEMBLY RH (w/ Occupant Classification System) |
| *5 | FRONT SEAT AIRBAG ASSEMBLY LH | *6 | FRONT SEAT AIRBAG ASSEMBLY RH |
| *7 | FRONT SEAT OUTER BELT ASSEMBLY LH | *8 | FRONT SEAT OUTER BELT ASSEMBLY RH |
| *A | for RHD | - | - |
| *1 | HORN BUTTON ASSEMBLY | *2 | INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY |
| *3 | LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY | *4 | FRONT SEAT AIRBAG ASSEMBLY LH |
| *5 | FRONT SEAT AIRBAG ASSEMBLY RH | *6 | FRONT SEAT OUTER BELT ASSEMBLY LH |
| *7 | FRONT SEAT OUTER BELT ASSEMBLY RH | - | - |
| *A | for LHD | - | - |
| *1 | AIRBAG ECU ASSEMBLY | *2 | OCCUPANT DETECTION ECU (w/ Occupant Classification System) |
| *3 | SEAT POSITION AIRBAG SENSOR (w/ Airbag Cut Off Switch) | *4 | AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY (w/ Airbag Cut Off Switch) |
| *5 | FRONT SEAT INNER BELT ASSEMBLY LH (w/ Occupant Classification System)
- SEAT BELT BUCKLE SWITCH LH |
*6 | SPIRAL CABLE SUB-ASSEMBLY |
| *7 | COMBINATION METER ASSEMBLY
- SRS WARNING LIGHT - PASSENGER AIRBAG ON/OFF INDICATOR (w/ Airbag Cut Off Switch or Occupant Classification System) - METER CIRCUIT PLATE |
*8 | DLC3 |
| *9 | INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
- A/BAG-IG2 FUSE - ECU-DCC NO. 2 FUSE - METER-IG2 FUSE |
- | - |
| *A | for RHD | - | - |
| *1 | AIRBAG ECU ASSEMBLY | *2 | SEAT POSITION AIRBAG SENSOR (w/ Airbag Cut Off Switch) |
| *3 | AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY (w/ Airbag Cut Off Switch) | *4 | SPIRAL CABLE SUB-ASSEMBLY |
| *5 | COMBINATION METER ASSEMBLY
- SRS WARNING LIGHT - PASSENGER AIRBAG ON/OFF INDICATOR (w/ Airbag Cut Off Switch) - METER CIRCUIT PLATE |
*6 | DLC3 |
| *7 | INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
- A/BAG-IG2 FUSE - ECU-DCC NO. 2 FUSE - METER-IG2 FUSE |
- | - |