Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS
BM3210E _V1 General _050435 INTRODUCTION _0249618 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  REPAIR PROCEDURE OF HEADLIGHT ASSEMBLY  


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

If the installation area of the headlight assembly is damaged, use the supply retainer for low-cost repair.

·

Make sure that the headlight assembly is not damaged.



INSTALL UPPER HEADLIGHT PROTECTOR RETAINER


a.
E337114

Cut off the part shaded in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.
E337115

Install the upper headlight protector retainer with the 2 screws.



INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER


a.
E337118

Cut off the part shaded in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.
E337119

Install the upper No. 2 headlight protector retainer with the 2 screws.



INSTALL LOWER HEADLIGHT PROTECTOR RETAINER


a.
E337116

Cut off the part shaded in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.
E337117

Install the lower headlight protector retainer with the 2 screws.