Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM
NM3210E _51 Engine / Hybrid System _050432 HYBRID / BATTERY CONTROL _0242219 HYBRID CONTROL SYSTEM DE DETAILS F

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  DETAILS  INVERTER  


CONSTRUCTION


a.

The inverter converts the boosted high-voltage direct current of the HV battery into 3-phase alternating current to drive MG1 and MG2.


b.

The activation of the power transistors is controlled by the Motor Generator ECU (MG ECU). In addition, the inverter transmits information that is needed for current control, such as the output amperage or voltage, to the hybrid vehicle control ECU via the MG ECU.


c.

The power transistors used in the inverter are Insulated Gate Bipolar Transistors (IGBTs).


d.

Each of the bridge circuits for MG1 and MG2 contains 6 IGBTs, mounted on the high voltage and high current module portion of an Intelligent Power Module (IPM). In addition, a signal processor/protective function processor has been integrated into the control portion of the IPM. The IPM is used to operate the power transistors based on signals from the MG ECU.

W132056E01
2.531,1.979 2.854,1.708 2.854,1.708 3.104,1.708 true 2.188,0.667 2.76,0.927 0.573,0.26 10 false MG1 4.531,0.667 5.104,0.927 0.573,0.26 10 false MG2 2.031,1.396 2.281,1.646 0.25,0.25 10 false U 2.365,1.396 2.583,1.635 0.219,0.24 10 false V 2.688,1.396 2.917,1.635 0.229,0.24 10 false W 3.198,1.625 4.177,2.198 0.979,0.573 10 false Inverter Current Sensor 1.927,5.25 2.844,5.563 0.917,0.313 10 false IPM for MG1 4.25,5.25 5.385,5.604 1.135,0.354 10 false IPM for MG2 3.448,6.094 4.177,6.333 0.729,0.24 10 false Inverter 4.396,1.406 4.646,1.656 0.25,0.25 10 false U 4.719,1.406 4.938,1.646 0.219,0.24 10 false V 5.042,1.406 5.271,1.646 0.229,0.24 10 false W 4.969,4.563 5.563,4.792 0.594,0.229 10 false IGBT