Home › General › INTRODUCTION › FEATURES
NM3210E _V1 General _050301 INTRODUCTION _0245034 FEATURES GE GENERAL F

INTRODUCTION  FEATURES  GENERAL  PERFORMANCE  


OUTLINE


a.

Hybrid System

i.

The hybrid system of this hybrid vehicle employs the Toyota Hybrid System-II (THS-II) under the "Hybrid Synergy Drive" concept*.


ii.

Toyota Hybrid System-II (THS-II) optimally performs cooperative control of the 2ZR-FXE engine, Motor Generator No. 1 (MG1) and Motor Generator No. 2 (MG2) in the P610 hybrid transaxle that provides excellent transmission performance for the front wheel drive system.


iii.

The hybrid system uses a high-output HV battery with a nominal voltage of DC 201.6, and available voltage system in which a boost converter increases the operating voltage of the system to a maximum voltage of DC 600 V.

HINT:

*: The "Hybrid Synergy Drive" concept consists of 4 key benefits: Fuel efficiency, low emissions, seamless acceleration, and silent performance.




b.

2ZR-FXE Engine

i.

The 2ZR-FXE engine is an in-line 4-cylinder, 1.8-liter, 16-valve DOHC engine. This engine uses a high-expansion ratio Atkinson cycle, Variable Valve Timing-intelligent (VVT-i) system, Direct Ignition System (DIS), Electronic Throttle Control System-intelligent (ETCS-i) and Exhaust Gas Recirculation (EGR) system employing a highly efficient EGR cooler. In addition, use of an electric water pump has enhanced warm-up performance and reduced cooling losses. Thus, improved engine performance, quietness, fuel economy, and cleaner emissions have been achieved.

Engine Type 2ZR-FXE
No. of Cyls. and Arrangement 4-cylinder, In-line
Valve Mechanism 16 valve DOHC, Chain Drive (with VVT-i)
Fuel System Sequential Multiport Fuel Injection (SFI)
Displacement cm3 (cu. in.) 1798 (109.7)
Max. Output [ECC] kW@rpm
(cu. in.)
71@5200
(96@5200)
Max. Torque [ECC] N*m@rpm (ft.*lbf@rpm) 142@3600
(105@3600)



c.

Transaxle

i.

A P610 hybrid vehicle transaxle is used.



d.

Suspension

i.

A MacPherson strut type independent suspension, which has L-type lower arms, is used for front.


ii.

A double-wishbone type independent suspension, which consists of an upper control arm, 2 lower suspension arms and a trailing arm, is used for rear.



e.

Brake

i.

A ventilated disc brake is provided for the front brake.


ii.

A solid disc brake is provided for the rear brake.


iii.

The following brake control systems are provided: Anti-lock Brake System (ABS), Electronic Brake force Distribution (EBD), Brake Assist, Traction Control (TRAC), Vehicle Stability Control (VSC), VSC and Cooperative Control with EPS*1 or VSC+*2 and Hill-start Assist Control.

*1: Models for general countries

*2: Models for Europe



f.

Steering

i.

A rack and pinion type steering gear assembly is used.


ii.

An Electric Power Steering (EPS) system is used.


iii.

A manual tilt and manual telescopic system is used.