Home › Engine / Hybrid System › 2ZR-FXE ENGINE MECHANICAL › ENGINE UNIT
NM3210E _51 Engine / Hybrid System _051743 2ZR-FXE ENGINE MECHANICAL _0249524 ENGINE UNIT GE GENERAL F

2ZR-FXE ENGINE MECHANICAL  ENGINE UNIT  GENERAL  GENERAL  


OUTLINE


a.

The 2ZR-FXE engine is an in-line, 4-cylinder, 1.8-liter, 16-valve DOHC engine.


b.

This engine uses a high-expansion ratio Atkinson cycle, Variable Valve Timing-intelligent (VVT-i) system, Direct Ignition System (DIS), Electronic Throttle Control System-intelligent (ETCS-i) and Exhaust Gas Recirculation (EGR) system employing a highly efficient EGR cooler. In addition, use of an electric water pump has enhanced warm-up performance and reduced cooling losses. Thus, improved engine performance, quietness, fuel economy, and cleaner emissions have been achieved.



SPECIFICATION


Engine Type 2ZR-FXE

*1: Destination package for South Korea

*2: Except destination package for South Korea

*3: Emission regulations differ depending on the specifications of the vehicle.

No. of Cyls. & Arrangement 4-cylinder, In-line
Valve Mechanism 16 valve DOHC, Chain Drive
(with VVT-i)
Combustion Chamber Pentroof Type
Flow of Intake and Exhaust Gasses Cross-flow
Fuel System Sequential Multiport Fuel Injection (SFI)
Ignition System Direct Ignition System (DIS)
Displacement cm3 (cu. in.) 1798 (109.7)
Bore x Stroke mm (in.) 80.5 X 88.3 (3.17 X 3.48)
Compression Ratio 13.0 : 1
Max. Output (EEC) kW@rpm 71@5200*1
72@5200*2
Max. Torque (EEC) N*m@rpm 142@3600
Valve Timing Intake Open 23° BTDC to 22° ATDC
Close 57° ABDC to 102° ABDC
Exhaust Open 35° BBDC
Close 9° ATDC
Spark Plug Type DENSO Made FC16HR-C9 (Iridium)
Plug Gap mm (in.) 0.8 to 0.9 (0.0315 to 0.0354)
Firing Order 1 - 3 - 4 - 2
Research Octane Number 91 or higher
Octane Rating 87 or higher
Emission Regulation*3 SULEV30
EURO VI
BR2

Destination package for South Korea
W132361E01
0.844,1.271 1.406,1.5 0.563,0.229 10 false Torque 1.792,0.083 2.25,0.302 0.458,0.219 10 false (N*m) 1.802,0.365 2.125,0.583 0.323,0.219 10 false 160 1.792,0.813 2.115,1.031 0.323,0.219 10 false 140 1.792,1.271 2.115,1.49 0.323,0.219 10 false 120 1.792,1.729 2.115,1.948 0.323,0.219 10 false 100 1.865,2.188 2.188,2.406 0.323,0.219 10 false 80 5.375,0.104 5.833,0.323 0.458,0.219 10 false (kW) 5.5,0.354 5.792,0.583 0.292,0.229 10 false 80 5.5,0.813 5.792,1.042 0.292,0.229 10 false 70 5.5,1.271 5.792,1.5 0.292,0.229 10 false 60 5.51,1.729 5.802,1.958 0.292,0.229 10 false 50 5.51,2.198 5.802,2.427 0.292,0.229 10 false 40 5.51,2.656 5.802,2.885 0.292,0.229 10 false 30 5.51,3.115 5.802,3.344 0.292,0.229 10 false 20 5.49,3.573 5.781,3.802 0.292,0.229 10 false 10 5.521,4.021 5.813,4.25 0.292,0.229 10 false 0 6.229,1.281 6.792,1.51 0.563,0.229 10 false Output 3.417,4.521 4.458,4.74 1.042,0.219 10 false Engine Speed 2.406,4.375 2.802,4.594 0.396,0.219 10 false 1000 2.885,4.375 3.281,4.594 0.396,0.219 10 false 2000 3.375,4.375 3.771,4.594 0.396,0.219 10 false 3000 3.854,4.375 4.25,4.594 0.396,0.219 10 false 4000 4.323,4.375 4.719,4.594 0.396,0.219 10 false 5000 4.802,4.375 5.198,4.594 0.396,0.219 10 false 6000 5.313,4.385 5.875,4.615 0.563,0.229 10 false (rpm)

Except destination package for South Korea
W130258E01
1.844,0.115 2.26,0.313 0.417,0.198 10 false (N*m) 5.406,0.135 5.781,0.313 0.375,0.177 10 false (kW) 1.854,0.344 2.188,0.573 0.333,0.229 10 false 160 1.854,0.813 2.198,0.979 0.344,0.167 10 false 140 1.865,1.281 2.125,1.479 0.26,0.198 10 false 120 1.865,1.729 2.177,1.896 0.313,0.167 10 false 100 1.938,2.198 2.146,2.385 0.208,0.188 10 false 80 5.479,0.333 5.688,0.521 0.208,0.188 10 false 80 5.5,0.813 5.688,1.031 0.188,0.219 10 false 70 5.5,1.271 5.719,1.521 0.219,0.25 10 false 60 5.51,1.729 5.76,1.917 0.25,0.188 10 false 50 5.51,2.188 5.719,2.385 0.208,0.198 10 false 40 5.51,2.646 5.688,2.854 0.177,0.208 10 false 30 5.51,3.115 5.74,3.281 0.229,0.167 10 false 20 5.5,3.573 5.74,3.781 0.24,0.208 10 false 10 2.396,4.375 2.708,4.594 0.313,0.219 10 false 1000 2.885,4.375 3.26,4.542 0.375,0.167 10 false 2000 3.375,4.375 3.76,4.563 0.385,0.188 10 false 3000 3.854,4.375 4.219,4.552 0.365,0.177 10 false 4000 4.323,4.375 4.667,4.542 0.344,0.167 10 false 5000 4.802,4.375 5.188,4.583 0.385,0.208 10 false 6000 3.344,4.531 4.344,4.75 1,0.219 10 false Engine Speed 0.917,1.25 1.417,1.5 0.5,0.25 10 false Torque 6.01,1.25 6.5,1.458 0.49,0.208 10 false Output 5.521,3.99 5.76,4.198 0.24,0.208 10 false 0 5.156,4.552 5.583,4.75 0.427,0.198 10 false (rpm)


MAIN FEATURES


a.

The 2ZR-FXE engine has achieved the following through the use of the items listed in the table below.

i.

High performance and reliability


ii.

Low noise and vibration


iii.

Lightweight and compact design


iv.

Good serviceability


v.

Clean emissions and fuel economy

Item i ii iii iv v

○: Applicable

-: Not applicable

*: Models with dual-passage cooling system

The high-expansion ratio Atkinson cycle is adopted. - - - - ○
Engine Proper An aluminum cylinder block sub-assembly is used. - - ○ - -
An offset crankshaft is used. ○ ○ - - ○
Spiny type liners are used. ○ - - - ○
Drilled V-shaped passages in the cylinder block sub-assembly are used. ○ - - - ○
The tumble keep shape is used for the top of the pistons. ○ - - - ○
The skirt portion of the piston has a resin coating applied to reduce friction. ○ ○ - - ○
Valve Mechanism A chain sub-assembly and No. 1 chain tensioner assembly are used. - ○ - ○ -
Valve lash adjuster assemblies are used. - ○ - ○ -
No. 1 valve rocker arm sub-assemblies are used. - ○ - - ○
The Variable Valve Timing-intelligent (VVT-i) system is used. ○ - - - ○
Intake and Exhaust System A plastic intake manifold is used. - - ○ - -
A linkless type throttle body assembly is used. - - ○ ○ -
A Step motor type Exhaust Gas Recirculation (EGR) valve is used. ○ - - - ○
A water-cooled type Exhaust Gas Recirculation (EGR) cooler is used. ○ - - - ○
A stainless steel exhaust manifold is used. - - ○ - ○
Three-Way Catalytic converters (TWCs) are used. - - - - ○
A 2-way exhaust control system is used. ○ ○ - - -
Fuel System 12-hole type fuel injector assemblies are used. ○ - - - ○
A fuel returnless system is used. - - ○ ○ -
Quick connectors are used to connect the fuel hoses and fuel pipes. - - - ○ -
Cooling System An electric engine water pump assembly is used. - - - - ○
A dual-passage cooling system is used.* ○ - - - ○
Ignition System A Direct Ignition System (DIS) is used. ○ - ○ ○ ○
Long-reach type iridium-tipped spark plugs are used. ○ - - ○ ○
Engine Control System The Electronic Throttle Control System-intelligent (ETCS-i) is used. ○ - - - ○
A Magneto-Resistance Element (MRE) type cam position sensor is used. ○ - - - -
A flat type knock control sensor is used. ○ - - - -