Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM
NM3210E _57 Power Source / Network _051769 NETWORKING _0249547 CAN COMMUNICATION SYSTEM GE GENERAL F

NETWORKING  CAN COMMUNICATION SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

The Controller Area Network (CAN) is a serial data communication network for real time application. It is a multiplex communication network equipped in a vehicle, and has communication speeds of 500 kbps (HS-CAN), and the ability to detect malfunctions.


b.

The HS-CAN consists of the diagnosis bus, bus 1, bus 2, bus 3, bus 4 and bus 5.


c.

The communication wire used is a twisted-pair wire. The bus line has a high line (2.5 V to 3.5 V of voltage is applied) and a low line (1.5 V to 2.5 V of voltage is applied).


d.

The terminating resistors for each bus are located as shown in the following table.

Bus Terminating Resistor Location Gateway Function Gateway Destination
CAN Diagnosis Bus Central Gateway ECU (Network Gateway ECU) Central Gateway ECU (Network Gateway ECU) to each bus
CAN Bus 1 Central Gateway ECU (Network Gateway ECU) Central Gateway ECU (Network Gateway ECU) to each bus
CAN Bus 2
·

Central Gateway ECU (Network Gateway ECU)

·

ECM


Central Gateway ECU (Network Gateway ECU) to each bus
CAN Bus 3 Central Gateway ECU (Network Gateway ECU) Central Gateway ECU (Network Gateway ECU) to each bus
CAN Bus 4
·

Central Gateway ECU (Network Gateway ECU)

·

Airbag ECU Assembly


Central Gateway ECU (Network Gateway ECU) to each bus
CAN Bus 5
·

Central Gateway ECU (Network Gateway ECU)

·

Combination Meter Assembly


Central Gateway ECU (Network Gateway ECU) to each bus