Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
NM3210E _59 Vehicle Exterior _051620 LIGHTING (EXT) _0250126 LIGHTING SYSTEM CO CONTROL F

LIGHTING (EXT)  LIGHTING SYSTEM  CONTROL  EMERGENCY BRAKE SIGNAL  


FUNCTION OF MAIN COMPONENTS


Component Function
Brake Booster with Master Cylinder Assembly
·

Skid Control ECU


Receives various signals and outputs an emergency brake signal to combination meter assembly.
Speed Sensor Detect the wheel speed of each of the 4 wheels.
Airbag ECU Assembly Outputs the acceleration information.
Stop Light Switch Assembly Detects when the brake pedal is depressed.
Combination Meter Assembly Receives an emergency brake signal and turns on the hazard warning lights.
Hazard Warning Switch Transmits a hazard warning switch on signal to the combination meter assembly.


SYSTEM CONTROL


a.

The activating and deactivating conditions for the emergency brake signal are as shown in the following table:

Condition Details
Emergency Brake Signal Operating Conditions When all of the following conditions are met, the emergency brake signal starts operating:
·

Vehicle speed is above 55 km/h (35 mph).

·

Driver is depressing the brake pedal.

·

Emergency braking is detected from the vehicle deceleration.


Emergency Brake Signal Ending Conditions When any of the following conditions is met, the emergency brake signal stops operating:
·

Driver has released the brake pedal.

·

Emergency braking is no longer detected from the vehicle deceleration.

·

Driver has operated the hazard warning switch.