Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM
RM3210E _57 Power Source / Network _047550 NETWORKING _0225119 LIN COMMUNICATION SYSTEM D

NETWORKING  LIN COMMUNICATION SYSTEM  SYSTEM DESCRIPTION  


LIN COMMUNICATION SYSTEM DESCRIPTION


The LIN communication system is used for communication between the components in the tables below. If communication cannot be performed through LIN communication such as when there is an open or short in a communication line, the master control ECU of the relevant system will store a DTC. Refer to the table below about the communication bus lines and connected components.

HINT:
·

Each component has a fail-safe function which operates in the event of a malfunction to protect the system and allow communication between other components to continue.

·

In the following table, "○" indicates that the function applies, and "-" indicates that it does not.



Door Bus Lines
Component Master Control LIN Communication DTC Output Function
Main Body ECU (Multiplex Network Body ECU) ○ ○
Power Window Regulator Motor Assembly (for Driver Door) - -
Power Window Regulator Motor Assembly (for Front Passenger Door) - -
Power Window Regulator Motor Assembly (for Rear LH Door) - -
Power Window Regulator Motor Assembly (for Rear RH Door) - -
Multiplex Network Master Switch Assembly - -
Sliding Roof ECU (Sliding Roof Drive Gear Sub-assembly)*1 - -
Double Lock Door Control Relay Assembly*2 - -

*1: w/ Sliding Roof System

*2: w/ Double Locking System


Certification Bus Lines
Component Master Control LIN Communication DTC Output Function
Certification ECU (Smart Key ECU Assembly) ○ ○
Hybrid Vehicle Control ECU - -
ID Code Box (Immobiliser Code ECU) - -