Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM
RM3210E _58 Vehicle Interior _047539 SUPPLEMENTAL RESTRAINT SYSTEMS _0225221 OCCUPANT CLASSIFICATION SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION SYSTEM  INITIALIZATION  


DESCRIPTION


a.

Zero point of the occupant classification sensors may deviate in the following situations. To ensure sensor accuracy, be sure to perform Zero Point Calibration.

1.

The occupant detection ECU is replaced.

HINT:

As the zero point is not automatically stored in a new occupant detection ECU, it is necessary to perform zero point calibration after replacing the occupant detection ECU.


2.

Accessories (seatback tray, seat cover, etc.) are installed.

HINT:

As the weight of accessories will be added to the weight of the occupant, the system will not be able to perform classification accurately.


3.

The front passenger seat is removed from the vehicle.

HINT:

As the seat frame will warp slightly when the bolts that are used to install the front passenger seat are tightened, the load applied to the occupant classification sensor will change and the system will not be able to perform classification accurately.


4.

Any of the bolts that are used to install the front passenger seat are removed and reinstalled.

HINT:

As the seat frame will warp slightly when the bolts that are used to install the front passenger seat are tightened, the load applied to the occupant classification sensor will change and the system will not be able to perform classification accurately.


5.

The passenger airbag ON/OFF indicator ("ON") illuminates when the front passenger seat is not occupied.

HINT:

If any load or pressure is applied to the occupant classification sensors, the system will not be able to perform classification accurately.


6.

The vehicle is brought to the workshop for repair due to an accident or a collision.

HINT:

If the seat frame or vehicle floor has become deformed and additional pressure is applied to the occupant classification sensor, the system will not be able to perform classification accurately.





ZERO POINT CALIBRATION


NOTICE:

Make sure that the front passenger seat is not occupied before performing the operation.


a.

Zero point calibration procedure

i.

Check that all of the following conditions are met:

·

The vehicle is parked on a level surface.

·

No objects are placed on the front passenger seat.

·

No objects are touching the front passenger seat.



ii.

Adjust the seat position according to the table below.

Adjustment Item Position
Slide Direction Rearmost position
Headrest Height Lowest position
Recline Angle Upright position


iii.

Turn the power switch off.


iv.

Connect the GTS to the DLC3.


v.

Turn the power switch on (IG).


vi.

Turn the GTS on.


vii.

Enter the following menus: Body Electrical / Occupant Detection / Utility / Zero Point Calibration.

Body Electrical > Occupant Detection > Utility
Tester Display
Zero Point Calibration
50005 394 4435

viii.

Perform zero point calibration by following the prompts on the GTS screen.

OK:

"Zero Point Calibration is complete." is displayed.


HINT:
·

Refer to the GTS operator's manual for further details.

·

If zero point calibration does not complete normally, perform this procedure again. If zero point calibration cannot be completed normally, replace the front seat adjuster assembly RH.