Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0229674 REAR VIEW MONITOR SYSTEM D

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


a.

Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the rear view monitor system seems to be malfunctioning, use the GTS to check for malfunctions and to perform repairs.




VEHICLE SIGNAL CHECK


a.

Check the item displayed for "REV" on the "Vehicle Signal Check Mode" screen.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>OPERATION CHECK



CAMERA SYNCHRONOUS ERROR HISTORY


HINT:

This function is used to check the date and time of occurrence of a camera synchronous error.


a.

Check camera synchronous error history.

i.

Connect the GTS to the DLC3.


ii.

Turn the power switch on (IG).


iii.

Turn the GTS on.


iv.

Enter the following menus: Body Electrical / Navigation System / Utility / Camera Synchronous Error History.

Body Electrical > Navigation System > Utility
Tester Display
Camera Synchronous Error History
50005 212 5285

v.

When an item is stored for Camera Synchronous Error History, record it before repairing the radio and display receiver assembly and rear television camera assembly.

HINT:

Camera Synchronous Error History can store up to 5 history data items. If a new camera synchronous error occurs when 5 data items have already been stored, the oldest data is cleared and the new data is stored.




b.

Clear camera synchronous error history.

i.

When DTCs are cleared using any of the following operations, Camera Synchronous Error History will be cleared as well.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR

·

Cleared using the GTS.

·

Cleared using the system check mode screen.

·

Cleared using the unit check mode screen.