Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SEAT POSITION SENSOR
RM3210E _58 Vehicle Interior _047539 SUPPLEMENTAL RESTRAINT SYSTEMS _0230377 SEAT POSITION SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SEAT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the seat position airbag sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system
Simple intelligent parking assist system
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY LH

Hide 72277A 2.REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR

a.
B432357

Disengage the clamp and disconnect the connector.


b.
B432358C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Pull the seat slide position sensor protector in the direction indicated by the arrow (1), to disengage the pin, and then slide the seat slide position sensor protector in the direction indicated by the arrows (2) shown in the illustration to remove it.


Hide 89178A 3.REMOVE SEAT POSITION AIRBAG SENSOR

a.
B432360

Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor.