Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › SFI SYSTEM(w/o Canister Pump Module)
RM3210E _51 Engine / Hybrid System _047494 2ZR-FXE ENGINE CONTROL _0231250 SFI SYSTEM(w/o Canister Pump Module) U

2ZR-FXE ENGINE CONTROL  SFI SYSTEM(w/o Canister Pump Module)  FAIL-SAFE CHART  


If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily or stops fuel injection.

DTC Code Component Fail-Safe Operation Fail-Safe Deactivation Condition
P003012
P003013
P101A9E
Air fuel ratio sensor heater The ECM turns off the air fuel ratio sensor heater. Power switch off
P003612
P003614
P102A9E
Heated oxygen sensor heater The ECM turns off the heated oxygen sensor heater. Power switch off
P006900
P222611
P222615
·

Manifold absolute pressure sensor

·

Atmospheric pressure sensor (ECM)


The ECM maintains the last learned atmospheric pressure value. Pass condition detected
P010012
P010014
Mass air flow meter sub-assembly The ECM calculates ignition timing according to the engine speed and throttle valve position. Pass condition detected
P010511
P010515
P01052A
Manifold absolute pressure sensor The ECM disables EGR valve operation Pass condition detected
P011011
P011015
Intake air temperature sensor The ECM estimates the intake air temperature to be 20°C (68°F). Pass condition detected
P011511
P011515
Engine coolant temperature sensor The ECM estimates the engine coolant temperature to be 80°C (176°F). Pass condition detected
P01E311
P01E315
No. 2 engine coolant temperature sensor
·

The flow shutting valve (water valve) opens.

·

The engine water pump assembly operates at maximum output.

·

Engine output is limited.


Power switch off
P012011
P012015
P01201C
P022011
P022015
P060444
P060647
P060A47
P060B49
P060E49
P065714
P06579E
P210014
P210015
P211900
P211904
P211977
P21352B
Electronic throttle control system The ECM cuts off throttle actuator current and the throttle valve is returned to a 5.5° throttle position by the return spring.
The ECM controls the fuel injection duration and ignition timing in accordance with the engine torque requested by the hybrid vehicle control ECU. Fuel-cut is performed intermittently.*
Pass condition detected and then power switch turned off
P032511
P032515
Knock control sensor The ECM sets the ignition timing to maximum retard. Power switch off
P035113
P035213
P035313
P035413
Ignition coil assembly The ECM cuts the fuel injection. Pass condition detected
P04019C
P040314
P140000
P140596
P141004
EGR valve assembly The ECM fully closes the EGR valve and stops EGR control. Pass condition detected
P059F73
P05A072
P05A211
P05A212
P05A213
P05A27E
P05A27F
P05B131
Swing grille actuator assembly The grille shutter system control is suspended. Normal system condition detected, power switch turned off then on (IG) and normal grille shutter closing and opening operation performed
P05B112
P05B114
Swing grille actuator assembly
·

Grille shutter closed position:

The grille shutter is fully opened and then grille shutter system control is suspended.

·

Grille shutter open position:

The grille shutter system control is suspended.


Normal system condition detected, power switch turned off then on (IG) and normal grille shutter closing and opening operation performed
P10AA00
·

EGR valve assembly

·

Air fuel ratio sensor


The ECM fully closes the EGR valve and stops EGR control. Power switch off
P148F00 Engine water pump assembly The engine water pump assembly performs intermittent operation. Power switch off
P223711
P223712
P223714
P223716
P223717
P22371A
P225111
P225112
Air fuel ratio sensor Air fuel ratio feedback control is stopped. Pass condition detected and then power switch turned off
P261A12
P261A14
Engine water pump assembly
·

Output duty ratio of the WPO terminal repeats a cycle of 0% for 30 seconds and then 85% for 5 seconds.

·

The engine water pump assembly is operated at the maximum speed.

·

When the engine coolant temperature reaches 105°C (221°F), the engine is stopped and the hybrid system is solely used to driving vehicle.


Power switch off
P261A13 Engine water pump assembly
·

Output duty ratio of the WPO terminal repeats a cycle of 0% for 30 seconds and then 85% for 5 seconds.

·

When the engine coolant temperature reaches 105°C (221°F), the engine is stopped and the hybrid system is solely used to driving vehicle.


Power switch off
P268172
P26819C
Dual-passage cooling system The flow shutting valve (water valve) opens. Power switch off
P268173 Dual-passage cooling system
·

The engine water pump assembly operates at maximum output.

·

Engine output is limited.


Power switch off

HINT:

*: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly.