Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0231469 HEADLIGHT ASSEMBLY A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY  REPAIR  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.

·

If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair.

·

Ensure that the headlight assembly is not damaged.



PROCEDURE

Hide 81194 1.INSTALL UPPER HEADLIGHT PROTECTOR RETAINER

a.
E337114

Cut off the part shaded in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.
E337115

Install the upper headlight protector retainer with the 2 screws.


Hide 81194B 2.INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER

a.
E337118

Cut off the part shaded in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.
E337119

Install the upper No. 2 headlight protector retainer with the 2 screws.


Hide 81196A 3.INSTALL LOWER HEADLIGHT PROTECTOR RETAINER

a.
E337116

Cut off the part shaded in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.
E337117

Install the lower headlight protector retainer with the 2 screws.