81560
1.INSPECT REAR COMBINATION LIGHT ASSEMBLY LH
| *a | Component without harness connected
(Rear Combination Light Assembly LH) |
Apply auxiliary battery voltage to the rear combination light assembly LH and check that the light comes on.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 3 (B)
Auxiliary battery negative (-) → Terminal 2 (E) |
Turn signal light comes on |
If the result is not as specified, replace the rear turn signal light bulb or rear combination light socket and wire sub-assembly LH.
Apply auxiliary battery voltage to the rear combination light assembly LH and check that the light comes on.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 4 (B)
Auxiliary battery negative (-) → Terminal 2 (E) |
Back-up light comes on |
If the result is not as specified, replace the back up light bulb or rear combination light socket and wire sub-assembly LH.
Apply auxiliary battery voltage to the rear combination light assembly LH and check that the light comes on.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 1 (TL)
Auxiliary battery negative (-) → Terminal 2 (E) |
Taillight comes on |
If the result is not as specified, replace the rear combination light lens and body or rear combination light socket and wire sub-assembly LH.
81550
2.INSPECT REAR COMBINATION LIGHT ASSEMBLY RH
| *a | Component without harness connected
(Rear Combination Light Assembly RH) |
Apply auxiliary battery voltage to the rear combination light assembly RH and check that the light comes on.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 3 (B)
Auxiliary battery negative (-) → Terminal 2 (E) |
Turn signal light comes on |
If the result is not as specified, replace the rear turn signal light bulb or rear combination light socket and wire sub-assembly RH.
Apply auxiliary battery voltage to the rear combination light assembly RH and check that the light comes on.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 4 (B)
Auxiliary battery negative (-) → Terminal 2 (E) |
Back-up light comes on |
If the result is not as specified, replace the back up light bulb or rear combination light socket and wire sub-assembly RH.
Apply auxiliary battery voltage to the rear combination light assembly RH and check that the light comes on.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 1 (TL)
Auxiliary battery negative (-) → Terminal 2 (E) |
Taillight comes on |
If the result is not as specified, replace the rear combination light lens and body or rear combination light socket and wire sub-assembly RH.