Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
81550N
1.REMOVE BACK-UP LIGHT BULB
|
Remove in this Direction |
Turn the rear combination light socket and wire sub-assembly with the back-up light bulb as shown in the illustration to disconnect them as a unit.
Remove the back-up light bulb from the rear combination light socket and wire sub-assembly.
81550L
2.REMOVE REAR TURN SIGNAL LIGHT BULB
|
Remove in this Direction |
Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.
Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.
81565
3.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY
Disengage the clamp.
Disconnect the connector to remove the rear combination light socket and wire sub-assembly.
81561D
4.REMOVE REAR COMBINATION LIGHT LENS AND BODY