Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0231480 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84330 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.
E343113C01
1.385,1.875 1.552,1.375 false 2.031,1.875 1.865,1.375 false 0.354,0.385 0.667,0.583 0.313,0.198 10 false *a 1.25,1.885 1.563,2.083 0.313,0.198 10 false TB 2.083,1.885 2.396,2.083 0.313,0.198 10 false E
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (TB) - 4 (E) Hazard warning signal switch off 1 MΩ or higher
Hazard warning signal switch on Below 50 Ω


If the result is not as specified, replace the hazard warning signal switch assembly.


b.
E343113C02
1.219,1.896 1.385,1.396 false 2.198,1.896 2.031,1.396 false 0.354,0.302 0.667,0.5 0.313,0.198 10 false *a 1.104,1.917 1.417,2.115 0.313,0.198 10 false ILL+ 2.167,1.917 2.479,2.115 0.313,0.198 10 false ILL-
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


Illumination Inspection

i.

Apply auxiliary battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 6 (ILL+)
Auxiliary battery negative (-) → Terminal 3 (ILL-)
Illuminates


If the result is not as specified, replace the hazard warning signal switch assembly.