Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM MAIN SWITCH
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0231481 AUTOMATIC HIGH BEAM MAIN SWITCH G

LIGHTING (EXT)  AUTOMATIC HIGH BEAM MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84970E 1.INSPECT AUTOMATIC HIGH BEAM MAIN SWITCH (NO. 2 COMBINATION SWITCH ASSEMBLY)

a.
E343114C01
1.813,1.469 1.646,1.885 false 2.01,1.469 2.177,1.885 false 0.5,0.417 0.813,0.615 0.313,0.198 10 false *a 2.188,1.917 2.5,2.115 0.313,0.198 10 false E 1.542,1.917 1.854,2.115 0.313,0.198 10 false +B
*a Component without harness connected
(Automatic High Beam Main Switch (No. 2 Combination Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
9 (+B) - 8 (E) Automatic high beam main switch (No. 2 combination switch assembly) not pressed 1 MΩ or higher
Automatic high beam main switch (No. 2 combination switch assembly) pressed Below 25 Ω


If the result is not as specified, replace the Automatic high beam main switch (No. 2 combination switch assembly).


b.
E343114C03
2.167,0.5 2.01,1.104 false 1.313,1.479 1.146,1.896 false 0.5,0.417 0.813,0.615 0.313,0.198 10 false *a 2.104,0.302 2.417,0.5 0.313,0.198 10 false ILL- 1,1.917 1.313,2.115 0.313,0.198 10 false ILL+
*a Component without harness connected
(Automatic High Beam Main Switch (No. 2 Combination Switch Assembly))


Illumination Inspection

i.

Apply auxiliary battery voltage to the Automatic high beam main switch (No. 2 combination switch assembly) and check that the switch illuminates.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 12 (ILL+)
Auxiliary battery negative (-) → Terminal 2 (ILL-)
Illuminates


If the result is not as specified, replace the Automatic high beam main switch (No. 2 combination switch assembly).