Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0231484 HEIGHT CONTROL SENSOR A

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during height control sensor sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear height control sensor sub-assembly LH Initialize No. 1 headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)

PROCEDURE

Hide 1.REMOVE REAR WHEEL (for LH Side)

Hide 89408C 2.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.
E341680C01
0.75,1.167 1.167,1.083 true 2.667,2.75 2.667,2.417 true 0.521,1.083 0.833,1.24 0.313,0.156 10 true *a 2.604,2.75 2.917,2.906 0.313,0.156 10 true *b
*a Clamp
*b Guide


Disconnect the connector.


b.

Disengage the clamp.


c.

Remove the 2 bolts.


d.

Disengage the guide to remove the rear height control sensor sub-assembly LH.

NOTICE:

If the rear height control sensor sub-assembly LH has been struck or dropped, replace it with a new one.