Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH
RM3210E _54 Brake _047516 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0232288 VSC OFF SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT VSC OFF SWITCH (COMBINATION SWITCH ASSEMBLY)

a.
C305912C62
2.156,1.469 2.406,1.781 true 1.927,1.083 2.104,0.563 true 0.188,0.115 0.5,0.313 0.313,0.198 10 false *a 2.104,0.406 2.417,0.625 0.313,0.219 10 false + 2.427,1.781 2.927,2.01 0.5,0.229 10 false E
*a Component without harness connected
(VSC OFF Switch (Combination Switch Assembly))


Make sure that there is no looseness in the locking part and the connecting part of the connector.

OK:

The connector is securely connected.



b.

Disconnect the VSC OFF switch (combination switch assembly) connector.


c.

Check both the connector case and the terminals for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (+) - 6 (E) Switch pushed Below 1 Ω
2 (+) - 6 (E) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the VSC OFF switch (combination switch assembly).