Home › Engine / Hybrid System › 2ZR-FXE COOLING › COOLING FAN SYSTEM
RM3210E _51 Engine / Hybrid System _047499 2ZR-FXE COOLING _0232548 COOLING FAN SYSTEM G

2ZR-FXE COOLING  COOLING FAN SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A345225

To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fans when inspecting the cooling fan system.


PROCEDURE

Hide 1.INSPECT COOLING FAN SYSTEM OPERATION AT LOW TEMPERATURES

CAUTION:

To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fans when inspecting the cooling fan system.


a.

Check and ensure the following conditions:

i.

The power switch is off.


ii.

The engine coolant temperature is less than 94°C (201°F).


iii.

The A/C switch is off.



b.

Turn the power switch on (IG) and wait for approximately 10 seconds. Check that the cooling fans are not operating.


c.

Check that the cooling fans operate when the water temperature sensor connector is disconnected.


Hide 2.INSPECT COOLING FAN SYSTEM OPERATION AT HIGH TEMPERATURES

CAUTION:

To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fans when inspecting the cooling fan system.


a.

Check and ensure the following conditions:

i.

Put the engine in inspection mode (maintenance mode).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


ii.

Warm up the engine.


iii.

The engine coolant temperature is less than 94°C (201°F).


iv.

The A/C switch is off.



b.

Start the engine. Check that the cooling fans are not operating.


c.

Check that the cooling fans start operating when the engine coolant temperature reaches approximately 96°C (205°F).

HINT:

This system can also be checked using the GTS.

Enter the following menus: Powertrain / Engine / Data List / Coolant Temperature


Powertrain > Engine > Data List
Tester Display
Coolant Temperature
50003 372 205