16031
1.INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Immerse the water inlet with thermostat sub-assembly in water and then gradually heat the water.
Check that the valve of the water inlet with thermostat sub-assembly opens at the specified temperature.
80 to 84°C (176 to 183°F)
If the result is not as specified, replace the water inlet with thermostat sub-assembly.
| *A | Compression Spring Shape: Tapered |
| *B | Compression Spring Shape: Straight |
| *a | Valve Lift |
| *b | Compression Spring |
Check the valve lift.
| Compression Spring Shape | Condition | Specified Condition |
|---|---|---|
| Tapered | 95°C (203°F) | 10 to 14 mm (0.394 to 0.551 in.) |
| Straight | 8 mm (0.315 in.) or more |
If the result is not as specified, replace the water inlet with thermostat sub-assembly.
Check that the valve is fully closed when the water inlet with thermostat sub-assembly is at low temperatures (below 77°C (171°F)).
If it is not fully closed, replace the water inlet with thermostat sub-assembly.