85242
1.REMOVE REAR WIPER BLADE
for Type A:
Slide the rear wiper arm head cap as shown in the illustration to disengage the 2 claws.
Lift the rear wiper arm and blade assembly as shown in the illustration.
Raise the rear wiper blade to the position where the claw disengages with a click sound as shown in the illustration.
Be careful not to damage the claw.
|
Remove in this Direction |
Pull the rear wiper blade as shown in the illustration to remove it from the rear wiper arm.
Place a piece of cloth between the rear wiper arm and back door glass to avoid damaging the back door glass.
85214R
2.REMOVE REAR WIPER RUBBER
Lift and pull the end of the rear wiper rubber over the blade stopper as shown in the illustration.
| *a | Stopper | - | - |
|
Push |
|
Pull Out |
|
Remove in this Direction | - | - |
Do not forcibly pull out the rear wiper rubber as the rear wiper rubber backing plates may be deformed or the claws of the rear wiper blade may be damaged.
Lightly pushing the middle of the rear wiper rubber will allow it to be removed more easily.
Remove the rear wiper rubber with the 2 rear wiper rubber backing plates from the rear wiper blade.
|
Remove in this Direction |
Remove the 2 rear wiper rubber backing plates from the rear wiper rubber.
85214R
3.INSTALL REAR WIPER RUBBER
|
Install in this Direction |
Install the 2 rear wiper rubber backing plates to the rear wiper rubber.
Install the backing plates facing the correct direction.
Insert the rear wiper rubber with the 2 rear wiper rubber backing plates through the second claw from the front of the rear wiper blade and then push it through each claw until the rear claw.
| *a | Second Claw | *b | Stopper |
|
Install in this Direction (1) |
|
Install in this Direction (2) |
|
Install in this Direction (3) | - | - |
After pushing the rear wiper rubber through the rear claw, pull it slightly over the rear stopper.
Slide the rear wiper rubber through the front claw.
| *a | Correct |
| *b | Incorrect |
Securely engage the rear wiper blade claw to the rear wiper rubber groove as shown in the illustration.
If the front claw of the rear wiper blade is not in the rear wiper rubber groove, grasp the rear wiper rubber and slide it up and down multiple times to insert the claw into the groove.
Applying a small amount of window washer fluid to the rear wiper rubber can make it easier to insert the claw into the groove.
85242
4.INSTALL REAR WIPER BLADE
|
Install in this Direction |
Push the rear wiper blade as shown in the illustration to install it to the rear wiper arm.
Engage the claw to install the rear wiper blade as shown in the illustration.
Be careful not to damage the claw.
Lower the rear wiper arm and blade assembly as shown in the illustration.
for Type A:
Slide the rear wiper arm head cap to engage the 2 claws as shown in the illustration.