85035
1.INSPECT WASHER NOZZLE SUB-ASSEMBLY
for Type A:
Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield.
Washer fluid contacts the windshield in the areas shown in the illustration.
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
|
Measurement | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 286.0 mm (11.3 in.) | B | 129.8 mm (5.11 in.) |
| C | 183.8 mm (7.24 in.) | - | - |
If the result is not as specified, replace the washer nozzle sub-assembly.
for Type B:
Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield.
Washer fluid contacts the windshield in the areas shown in the illustration.
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
|
Measurement | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 294.8 mm (11.6 in.) | B | 141.1 mm (5.56 in.) |
| C | 156.4 mm (6.16 in.) | - | - |
If the result is not as specified, replace the washer nozzle sub-assembly.