Home › Vehicle Interior › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Power Seat)
RM3210E _58 Vehicle Interior _047549 SEAT _0234657 LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Power Seat) A

SEAT  LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the lumbar support adjuster assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system
Simple intelligent parking assist system
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

CAUTION:
·

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Lumbar support adjuster assembly is available only on the driver side.

·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY LH

Hide 71074S 2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 71868A 3.REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD LH

Hide 71812D 4.REMOVE FRONT SEAT CUSHION SHIELD LH

Hide 71862 5.REMOVE FRONT SEAT INNER CUSHION SHIELD LH

Hide 6.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 71931 7.REMOVE FRONT SEAT HEADREST SUPPORT

Hide 8.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Hide 72760D 9.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH

a.
B439754

Disconnect the lumbar support adjuster assembly LH connector.


b.

Disengage the clamp.


c.
B439755

Disengage the 2 claws to remove the 2 front seatback edge protectors from the front seatback frame sub-assembly LH.


d.
B439756C01
0,0 0,0 false
V113147

Remove in this direction


Remove the lumbar support adjuster assembly LH from the front seatback frame sub-assembly LH as shown in the illustration.


Hide 71587 10.REMOVE FRONT SEATBACK EDGE PROTECTOR