The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seatback heater assembly removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY LH
71074S
2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
71868A
3.REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD LH
71812D
4.REMOVE FRONT SEAT CUSHION SHIELD LH
71862
5.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
6.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
71931
7.REMOVE FRONT SEAT HEADREST SUPPORT
8.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
71074S
9.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
87510N
10.REMOVE FRONT SEATBACK HEATER ASSEMBLY LH
Remove the 25 tag pins and front seatback heater assembly LH from the separate type front seatback cover.