Home › Vehicle Interior › SEAT › LUMBAR SWITCH(for Manual Seat)
RM3210E _58 Vehicle Interior _047549 SEAT _0234666 LUMBAR SWITCH(for Manual Seat) G

SEAT  LUMBAR SWITCH(for Manual Seat)  INSPECTION  


PROCEDURE

Hide 84922A 1.INSPECT FRONT LUMBAR POWER SEAT SWITCH (Driver Seat)

a.
B442254C01
1.25,2.5 1,2.083 1,2.083 0.833,2.083 false 2.25,2.5 2.667,2.083 2.667,2.083 2.833,2.083 false 1.385,1.01 1,0.583 1,0.583 0.833,0.583 false 2.417,1 2.667,0.583 2.667,0.583 2.833,0.583 false 0.604,1.677 0.917,1.833 0.313,0.156 10 false *B 2.854,0.5 3.167,0.656 0.313,0.156 10 false *a 0.667,0.5 0.979,0.656 0.313,0.156 10 false *b 0.854,3.417 1.167,3.573 0.313,0.156 10 false *c 0.521,0.094 0.833,0.25 0.313,0.156 10 false *A 0.688,2 1,2.156 0.313,0.156 10 false *a 2.854,2.01 3.167,2.167 0.313,0.156 10 false *b
*A for LHD
*B for RHD
*a Front Lumber Power Seat (Release)
*b Front Lumber Power Seat (Hold)
*c Component without harness connected
(Front Lumbar Power Seat Switch (Driver Seat))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 - 2 Front lumber power seat (Hold) pressed Below 1 Ω
3 - 4
5 - 4 Off
3 - 4
3 - 2 Front lumber power seat (Release) pressed
5 - 4


If the result is not as specified, replace the front lumbar power seat switch (Driver Seat).