Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › SFI SYSTEM(w/ Canister Pump Module)
RM3210E _51 Engine / Hybrid System _047494 2ZR-FXE ENGINE CONTROL _0236137 SFI SYSTEM(w/ Canister Pump Module) D

2ZR-FXE ENGINE CONTROL  SFI SYSTEM(w/ Canister Pump Module)  CHECK MODE PROCEDURE  


HINT:

Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect malfunctions that cannot be detected in normal mode.


NOTICE:

All of the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the power switch is turned from on (IG) to on (ACC) or off while in check mode. Before changing modes, always check for and note any DTCs and freeze frame data.


CHECK MODE PROCEDURE


a.

Check and ensure the following conditions:

i.

Auxiliary battery voltage is 11 V or higher.


ii.

Accelerator pedal fully released.


iii.

Park (P) is selected.


iv.

A/C switch is off.



b.

Turn the power switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the power switch on (IG).


e.

Turn the GTS on.


f.

Enter the following menus: Powertrain / Engine / Utility / Check Mode.

Powertrain > Engine > Utility
Tester Display
Check Mode
50005 372 1

g.

Change the ECM from normal mode to check mode.


h.
A283579E01
0.26,0.76 0.573,0.958 0.313,0.198 10 ON 0.25,1.313 0.708,1.563 0.458,0.25 10 OFF 2.031,0.417 2.948,0.635 0.917,0.219 10 0.13 seconds 1.927,1.792 2.844,2.01 0.917,0.219 10 0.13 seconds

Check that the MIL flashes as shown in the illustration.


i.

Turn the power switch on (READY).


j.

Check that the MIL turns off.


k.

Simulate the conditions of the malfunction described by the customer.


l.

Check for DTCs and freeze frame data using the GTS.