If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily or stops fuel injection.
| DTC Code | Component | Fail-Safe Operation | Fail-Safe Deactivation Condition |
|---|---|---|---|
| P001100 | VVT system | Idle up (control of combustion decreased). | Pass condition detected |
| P003012
P003013 P101A9E |
Air fuel ratio sensor heater | The ECM turns off the air fuel ratio sensor heater. | Power switch off |
| P003612
P003614 P102A9E |
Heated oxygen sensor heater | The ECM turns off the heated oxygen sensor heater. | Power switch off |
| P006900
P222611 P222615 |
·
Manifold absolute pressure sensor ·
Atmospheric pressure sensor (ECM) |
The ECM maintains the last learned atmospheric pressure value. | Pass condition detected |
| P010012
P010014 P010016 P010017 |
Mass air flow meter sub-assembly | The ECM calculates ignition timing according to the engine speed and throttle valve position. | Pass condition detected |
| P011011
P011015 |
Intake air temperature sensor | The ECM estimates the intake air temperature to be 20°C (68°F). | Pass condition detected |
| P011511
P011515 |
Engine coolant temperature sensor | The ECM estimates the engine coolant temperature to be 80°C (176°F). | Pass condition detected |
| P012011
P012015 P01201C P022011 P022015 P060444 P060647 P060A47 P060B49 P060E49 P065714 P06579E P210014 P210015 P211900 P211904 P211977 P21352B |
Electronic throttle control system | The ECM cuts off throttle actuator current and the throttle valve is returned to a 5.5° throttle position by the return spring.
The ECM controls the fuel injection duration and ignition timing in accordance with the engine torque requested by the hybrid vehicle control ECU. Fuel-cut is performed intermittently.* |
Pass condition detected and then power switch turned off |
| P032511
P032515 |
Knock control sensor | The ECM sets the ignition timing to maximum retard. | Power switch off |
| P035113
P035213 P035313 P035413 |
Ignition coil assembly | The ECM cuts the fuel injection. | Pass condition detected |
| P04019C
P040314 P140000 P140596 P141004 |
EGR valve assembly | The ECM fully closes the EGR valve and stops EGR control. | Pass condition detected |
| P059F73
P05A072 P05A074 P05A211 P05A212 P05A213 P05A27E P05A27F P05B131 |
Swing grille actuator assembly | The grille shutter system control is suspended. | Normal system condition detected, power switch turned off then on (IG) and normal grille shutter closing and opening operation performed |
| P05B112
P05B114 |
Swing grille actuator assembly | ·
Grille shutter closed position: The grille shutter is fully opened and then grille shutter system control is suspended. ·
Grille shutter open position: The grille shutter system control is suspended. |
Normal system condition detected, power switch turned off then on (IG) and normal grille shutter closing and opening operation performed |
| P10AA00 | ·
EGR valve assembly ·
Air fuel ratio sensor |
The ECM fully closes the EGR valve and stops EGR control. | Power switch off |
| P148F00 | Engine water pump assembly | The engine water pump assembly performs intermittent operation. | Power switch off |
| P211172
P211173 |
Electronic throttle control system | The ECM stops the engine and the vehicle can be driven using solely the hybrid system.* | Pass condition detected and then power switch turned off |
| P223711
P223712 P223714 P223716 P223717 P22371A P225111 P225112 |
Air fuel ratio sensor | Air fuel ratio feedback control is stopped. | Pass condition detected and then power switch turned off |
| P261A12
P261A14 |
Engine water pump assembly | ·
Output duty ratio of the WPO terminal repeats a cycle of 0% for 30 seconds and then 85% for 20 seconds. ·
The engine water pump assembly is operated at the maximum speed. ·
When the engine coolant temperature reaches 105°C (221°F), the engine is stopped and the hybrid system is solely used to driving vehicle. |
Power switch off |
| P261A13 | Engine water pump assembly | ·
Output duty ratio of the WPO terminal repeats a cycle of 0% for 30 seconds and then 85% for 20 seconds. ·
When the engine coolant temperature reaches 105°C (221°F), the engine is stopped and the hybrid system is solely used to driving vehicle. |
Power switch off |
*: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly.