Home › Vehicle Interior › LIGHTING (INT) › BACK DOOR COURTESY SWITCH
RM3210E _58 Vehicle Interior _047531 LIGHTING (INT) _0236250 BACK DOOR COURTESY SWITCH G

LIGHTING (INT)  BACK DOOR COURTESY SWITCH  INSPECTION  


PROCEDURE

Hide 69350 1.INSPECT BACK DOOR LOCK ASSEMBLY

a.

Check the operation of the door lock motor.

i.
B429563C02
0.51,3.188 0.823,3.385 0.313,0.198 10 false *a 0.667,0.229 0.979,0.427 0.313,0.198 10 false *b 0.792,2.021 1.104,2.219 0.313,0.198 10 false *c
*a Component without harness connected
(Back Door Lock Assembly)
*b Close (Lock)
*c Open (Unlock)


Move the door lock to the close (lock) position.


ii.

Apply auxiliary battery voltage and check the operation of the door lock motor.

OK:
Auxiliary Battery Connection Result
Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Terminal 2
Back door lock motor open (unlock) operation


If the result is not as specified, replace the back door lock assembly.



b.

Check the operation of the back door courtesy switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - 3 Closed (Locked) 10 kΩ or higher
2 - 3 Open (Unlocked) Below 1 Ω


If the result is not as specified, replace the back door lock assembly.