Home › Engine / Hybrid System › 2ZR-FXE EMISSION CONTROL › EMISSION CONTROL SYSTEM(w/o Canister Pump Module)
RM3210E _51 Engine / Hybrid System _047497 2ZR-FXE EMISSION CONTROL _0236604 EMISSION CONTROL SYSTEM(w/o Canister Pump Module) G

2ZR-FXE EMISSION CONTROL  EMISSION CONTROL SYSTEM(w/o Canister Pump Module)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.VISUALLY CHECK HOSES, CONNECTIONS AND GASKETS

a.

Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil level dipstick, oil filler cap sub-assembly, ventilation hose or other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in any part of the air induction system between the throttle body with motor assembly and cylinder head sub-assembly will cause engine failure or engine malfunctions.



If any defects are found, replace parts as necessary.


Hide 2.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

CAUTION:
A345137

To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fans when working in the engine compartment with the engine running or the power switch on (IG).


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Put the engine in inspection mode (maintenance mode).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


e.
A377760

Slide the clip and disconnect the No. 1 fuel vapor feed hose from the purge valve (purge VSV).


f.

Enter the following menus: Powertrain / Engine / Active Test / Activate the Evap Purge VSV.

Powertrain > Engine > Active Test
Tester Display
Activate the EVAP Purge VSV
50004 372 1

g.

Check that vacuum occurs at the purge valve (purge VSV) port.


h.

If vacuum does not occur, check the following items.

·

Purge valve (purge VSV)

·

Clogging in the No. 2 fuel vapor feed hose that connects the intake manifold and purge valve (purge VSV)



i.

Exit Active Test mode and connect the No. 1 fuel vapor feed hose.

If the result is not as specified, replace the purge valve (purge VSV), wire harness or ECM.


j.

Enter the following menus: Powertrain / Engine / Data List / EVAP (Purge) VSV.

Powertrain > Engine > Data List
Tester Display
EVAP (Purge) VSV
50003 372 226

k.

Warm up the engine and drive the vehicle.


l.

Confirm that the purge valve (purge VSV) opens.

If the result is not as specified, replace the purge valve (purge VSV), wire harness or ECM.