Home › Engine / Hybrid System › 2ZR-FXE EMISSION CONTROL › FUEL TANK PRESSURE SENSOR(w/ Canister Pump Module)
RM3210E _51 Engine / Hybrid System _047497 2ZR-FXE EMISSION CONTROL _0236611 FUEL TANK PRESSURE SENSOR(w/ Canister Pump Module) A

2ZR-FXE EMISSION CONTROL  FUEL TANK PRESSURE SENSOR(w/ Canister Pump Module)  INSTALLATION  


PROCEDURE

Hide 89461 1.INSTALL FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR)

a.
A318818C01
0.375,1.521 0.542,1.521 0.542,1.521 0.906,1.25 true 2.375,1.01 2.479,1.51 2.479,1.51 2.646,1.51 true 2.594,0.875 2.844,0.875 false 1.333,1.135 1.375,1.5 1.375,1.5 1.479,1.5 false 1.552,1.427 1.865,1.583 0.313,0.156 10 false *1 0.146,1.448 0.458,1.604 0.313,0.156 10 false *a 2.688,1.427 3,1.583 0.313,0.156 10 false *b 2.938,0.792 3.25,0.948 0.313,0.156 10 false *1
*1 Tube Joint Clip
*a O-ring
*b Collar


Push the fuel tank pressure sensor (vapor pressure sensor) onto the fuel tank assembly, then install the tube joint clip.

NOTICE:
·

Check that there are no scratches or foreign matter around the connecting parts of the fuel tank pressure sensor (vapor pressure sensor) and fuel suction plate sub-assembly before performing this work.

·

Check that the fuel suction plate sub-assembly is securely inserted to the end of the fuel tank pressure sensor (vapor pressure sensor).

·

Check that the tube joint clip is on the collar of the fuel tank pressure sensor (vapor pressure sensor).

·

After installing the tube joint clip, check that the fuel tank pressure sensor (vapor pressure sensor) cannot be pulled out.




Hide 58325E 2.INSTALL REAR FLOOR SERVICE HOLE COVER

Hide 82817B 3.INSTALL NO. 3 WIRING HARNESS PROTECTOR

Hide 72693 4.INSTALL REAR SEAT CUSHION LOCK HOOK

Hide 5.INSTALL REAR SEAT CUSHION ASSEMBLY