Home › Engine / Hybrid System › 2ZR-FXE EMISSION CONTROL › PCV VALVE
RM3210E _51 Engine / Hybrid System _047497 2ZR-FXE EMISSION CONTROL _0236614 PCV VALVE A

2ZR-FXE EMISSION CONTROL  PCV VALVE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during PCV valve (ventilation valve sub-assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body assembly

·

Cleaning the deposits from the throttle body assembly


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)w/ Canister Pump Module
(Click here)w/o Canister Pump Module

PROCEDURE

Hide 12261 2.DISCONNECT VENTILATION HOSE

a.
A377753

Slide the clip and disconnect the ventilation hose from the PCV valve (ventilation valve sub-assembly).


Hide 12204 3.REMOVE PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)

a.
A377754

Using a 22 mm ball joint lock nut wrench, remove the PCV valve (ventilation valve sub-assembly) from the No. 1 ventilation case.