Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM(w/o Occupant Classification System)
RM3210E _58 Vehicle Interior _047538 SEAT BELT _0237552 SEAT BELT WARNING SYSTEM(w/o Occupant Classification System) W

SEAT BELT  SEAT BELT WARNING SYSTEM(w/o Occupant Classification System)  CUSTOMIZE PARAMETERS  


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.

·

These buzzers should be ON for safe driving. Perform this procedure only if it is necessary to set the buzzer to OFF (disabled).



Customizing with the GTS


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Customize Setting / Warning.


e.

Select the setting by referring to the table below.

Warning
Tester Display Description Default Setting ECU
Driver Side Seatbelt Warning Buzzer Function to sound the driver seat belt warning buzzer ON 0:OFF,1:ON Meter circuit plate
Front Passenger Side Seatbelt Warning Buzzer Function to sound the front passenger seat belt warning buzzer ON 0:OFF,1:ON Meter circuit plate
Rear Seatbelt Warning Buzzer Function to sound the rear seat belt warning buzzer ON 0:OFF,1:ON Meter circuit plate
50006 7
HINT:

This setting is only valid when the vehicle is driven at 20 km/h (12 mph) or more.