84720J
1.INSPECT PATTERN SELECT SWITCH ASSEMBLY (VEHICLE APPROACHING SPEAKER SWITCH)
| *a | Component without harness connected
(Pattern Select Switch Assembly (Vehicle Approaching Speaker Switch)) |
| *b | Indicator |
| *c | Illumination |
Vehicle approaching speaker switch Inspection
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (IG) - 14 (ECU) | Switch on | Below 1 Ω |
| Switch off | 10 kΩ or higher |
If the result is not as specified, replace the pattern select switch assembly (vehicle approaching speaker switch).
Illumination Inspection
Apply auxiliary battery voltage to the vehicle approaching speaker switch and check that the switch illuminates.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 13 (ILL+)
Auxiliary battery negative (-) → Terminal 2 (ILL-) |
Illuminates |
If the result is not as specified, replace the pattern select switch assembly (vehicle approaching speaker switch).
Indicator Inspection
Apply auxiliary battery voltage to the vehicle approaching speaker switch and check that the indicator illuminates.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 6 (IG)
Auxiliary battery negative (-) → Terminal 11 (IND) |
Illuminates |
If the result is not as specified, replace the pattern select switch assembly (vehicle approaching speaker switch).