When a malfunction is detected between various ECUs and sensors, these DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0101 | Lost Communication with TCM | While the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the TCM (hybrid vehicle control ECU) and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
TCM (Hybrid vehicle control ECU) ·
Forward recognition camera |
| U0123 | Lost Communication with Yaw Rate Sensor Module | While the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the yaw rate sensor (airbag ECU assembly) and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Yaw rate sensor (Airbag ECU assembly) ·
Forward recognition camera |
| U0129 | Lost Communication with Brake System Control Module | 2 seconds after the power switch is turned on (IG), a communication error between the skid control ECU (brake booster with master cylinder assembly) and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Skid control ECU (Brake booster with master cylinder assembly) ·
Forward recognition camera |
| U0142 | Lost Communication with Body Control Module "B" | 2 seconds after the power switch is turned on (IG), a communication error between the main body ECU (multiplex network body ECU) and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Main body ECU (Multiplex network body ECU) ·
Forward recognition camera |
| U0293 | Lost Communication with HV ECU | 2 seconds after the power switch is turned on (IG), a communication error between the hybrid vehicle control ECU and the forward recognition camera is detected for approximately 5 seconds. | ·
CAN communication system ·
Hybrid vehicle control ECU ·
Forward recognition camera |
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DTC CHECK / CLEAR
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Turn the power switch on (IG) and wait 2 seconds or more.
Drive the vehicle at a speed of 1 km/h or 1 mph or more for 5 seconds or more.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U0101, U0123, U0129, U0142 and U0293 are not output | A |
| DTC U0101, U0123, U0129, U0142 or U0293 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING