Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM(w/ Steering Control)
RM3210E _51 Engine / Hybrid System _047527 CRUISE CONTROL _0239265 LANE DEPARTURE ALERT SYSTEM(w/ Steering Control) D

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM(w/ Steering Control)  CUSTOMIZE PARAMETERS  


CUSTOMIZE LANE DEPARTURE ALERT SYSTEM


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



HINT:

The following items can be customized.


a.

Customizing with the Multi-information display

i.

Turn the power switch on (IG).


ii.

Enter the following menus: Settings Tab / Settings / Lane Departure Alert Setup


iii.

Select the setting by referring to the table below.


iv.

Change the settings of the lane departure alert system using the steering pad switch assembly.

HINT:

Each item is displayed on the "Setting" screen on the multi-information display.


Lane Departure Alert System
Display Content Setting Default
Steering Assist LDA steering control function On/Off On
Warning Sensitivity Timing of lane departure alert High/Standard Standard
Vehicle Sway Warning Vehicle sway warning function On/Off On
Sway Sensitivity Sway warning sensitivity High/Standard/Low Standard