The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect objects in front of the vehicle. Based on signals from the millimeter wave radar sensor assembly, the driving support ECU assembly sends pre-crash safety system control operation signals. These DTCs are stored when a communication malfunction occurs between ECUs that perform pre-crash safety system control.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0125 | Lost Communication with Yaw Rate Sensor Module | When the power switch is on (IG), a communication error between the yaw rate sensor (airbag ECU assembly) and the driving support ECU is detected for approximately 1 second. | ·
CAN communication system ·
Yaw rate sensor (Airbag ECU assembly) ·
Driving support ECU assembly ·
Wire harness or connector |
| U0126 | Lost Communication with Steering Angle Sensor Module | When the power switch is on (IG), a communication error between the steering sensor and the driving support ECU assembly is detected for approximately 4 seconds. | ·
CAN communication system ·
Steering sensor ·
Driving support ECU assembly ·
Wire harness or connector |
| U0129 | Lost Communication with Brake System Control Module | When the power switch is on (IG), a communication error between the skid control ECU (brake booster with master cylinder assembly) and the driving support ECU assembly is detected for approximately 3 seconds. | ·
CAN communication system ·
Skid control ECU (Brake booster with master cylinder assembly) ·
Driving support ECU assembly ·
Wire harness or connector |
| U0293 | Lost Communication with HV ECU | When the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the hybrid vehicle control ECU and the driving support ECU assembly is detected for approximately 5 seconds. | ·
CAN communication system ·
Hybrid vehicle control ECU ·
Driving support ECU assembly ·
Wire harness or connector |
Clear the DTCs.
Click hereVehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Drive the vehicle at a speed of 5 km/h (4 mph) or more for 5 seconds or more.
Check for DTCs.
Click hereVehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U0125, U0126, U0129 and U0293 are not output | A |
| DTC U0125, U0126, U0129 or U0293 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING