Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Radio and Display Type)
RM3210E _56 Audio / Visual / Telematics _047511 NAVIGATION / MULTI INFO DISPLAY _0239522 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Navigation Voice Circuit between Radio Receiver and Stereo Component Amplifier  


DESCRIPTION

This circuit is used when the voice guidance of the navigation system is on or the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the navigation ECU sends signals to the stereo component amplifier assembly via the radio and display receiver assembly.

WIRING DIAGRAM

E268439E38
0.24,2.823 2.667,3.073 2.427,0.25 10 false Radio and Display Receiver Assembly 0.24,2.667 0.792,3.01 0.552,0.344 10 false F33 0.979,0.646 1.323,0.885 0.344,0.24 10 false RL+ 1,1.417 1.344,1.656 0.344,0.24 10 false RL- 5.927,0.646 6.271,0.885 0.344,0.24 10 false II1+ 5.667,2.625 6.01,2.917 0.344,0.292 10 false F61 1.365,0.542 1.573,0.76 0.208,0.219 10 false 2 1.365,1.323 1.573,1.542 0.208,0.219 10 false 6 5.646,0.531 5.896,0.74 0.25,0.208 10 false 15 5.646,1.313 5.896,1.51 0.25,0.198 10 false 14 5.635,2.115 5.896,2.333 0.26,0.219 10 false 18 5.927,1.438 6.271,1.677 0.344,0.24 10 false II1- 5.927,2.219 6.417,2.427 0.49,0.208 10 false SLD1 3.26,1.75 4.01,1.969 0.75,0.219 10 false (Shielded) 5.667,2.792 6.875,3.208 1.208,0.417 10 false Stereo Component Amplifier Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
a.

Disconnect the F33 radio and display receiver assembly connector.


b.

Disconnect the F61 stereo component amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester connection Condition Specified condition
F61-15 (II1+) - F33-2 (RL+) Always Below 1 Ω
F61-14 (II1-) - F33-6 (RL-) Always Below 1 Ω
F61-18 (SLD1) - Body ground Always 10 kΩ or higher
F61-15 (II1+) or F33-2 (RL+) - Body ground Always 10 kΩ or higher
F61-14 (II1-) or F33-6 (RL-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR