The radio and display receiver assembly receives a reverse signal from the BKUP LP relay.
Check that the back-up light comes on.
The back-up light comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F31 radio and display receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F31-2 (REV) - Body ground | Power switch on (IG)
Reverse (R) selected |
11 to 14 V |
| F31-2 (REV) - Body ground | Power switch on (IG)
Reverse (R) not selected |
Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG