Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Radio and Display Type)
RM3210E _56 Audio / Visual / Telematics _047511 NAVIGATION / MULTI INFO DISPLAY _0239522 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Vehicle Speed Signal Circuit between Radio Receiver and Extension Module  


DESCRIPTION

The navigation ECU receives a vehicle speed signal from the radio and display receiver assembly and information from the navigation antenna assembly, and then adjusts vehicle position.

WIRING DIAGRAM

E261261E47
1.24,1.115 1.854,1.313 0.615,0.198 10 false SPDO 5.531,1.115 6.146,1.313 0.615,0.198 10 false SPD 1.719,0.99 2.333,1.188 0.615,0.198 10 false 2 5.323,1 5.646,1.198 0.323,0.198 10 false 5 0.5,1.948 1.115,2.146 0.615,0.198 10 false e2 0.51,2.104 2.292,2.469 1.781,0.365 10 false Radio and Display Receiver Assembly 5.427,2 6.042,2.198 0.615,0.198 10 false e4 5.427,2.156 6.417,2.396 0.99,0.24 10 false Navigation ECU

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the e2 radio and display receiver assembly connector.


b.

Disconnect the e4 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
e2-2 (SPDO) - e4-5 (SPD) Always Below 1 Ω
e2-2 (SPDO) or e4-5 (SPD) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR