Home › Vehicle Interior › METER / GAUGE / DISPLAY › LIGHT CONTROL RHEOSTAT
RM3210E _58 Vehicle Interior _047509 METER / GAUGE / DISPLAY _0232445 LIGHT CONTROL RHEOSTAT G

METER / GAUGE / DISPLAY  LIGHT CONTROL RHEOSTAT  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT LIGHT CONTROL RHEOSTAT (COMBINATION SWITCH ASSEMBLY)

a.
E342180C01
1.292,3.115 1.688,2.698 false 2.344,3.063 1.969,2.688 false 0.26,0.177 0.573,0.333 0.313,0.156 10 false *a 1.052,3.115 1.365,3.271 0.313,0.156 10 false RV 2.302,3.135 2.615,3.292 0.313,0.156 10 false E
*a Component without harness connected
(Light Control Rheostat Switch (Combination Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
8 (RV) - 6 (E) Light control rheostat up switch pressed Below 1 Ω
Light control rheostat up switch not pressed 10 kΩ or higher
8 (RV) - 6 (E) Light control rheostat down switch pressed 1.71 to 1.89 kΩ
Light control rheostat down switch not pressed 10 kΩ or higher


If the result is not as specified, replace the light control rheostat switch (combination switch assembly).


b.
E342180C02
1.052,3.073 1.385,2.677 false 2.385,2.896 2.01,2.521 false 0.26,0.177 0.573,0.333 0.313,0.156 10 false *a 0.938,3.115 1.271,3.302 0.333,0.188 10 false ILL+ 2.375,2.938 2.688,3.094 0.313,0.156 10 false ILL-
*a Component without harness connected
(Light Control Rheostat Switch (Combination Switch Assembly))


Illumination Inspection

i.

Apply auxiliary battery voltage to the light control rheostat switch (combination switch assembly) and check that it illuminates.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 10 (ILL+)
Auxiliary battery negative (-) → Terminal 1 (ILL-)
Illuminates


If the result is not as specified, replace the light control rheostat switch (combination switch assembly).