The combination meter mirror ECU communicates with the ECM, hybrid vehicle control ECU, main body ECU (multiplex network body ECU), radio and display receiver assembly*1, navigation receiver assembly*2, forward recognition camera*3 and driving support ECU assembly*4 via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | When IG voltage is 9.5 V or more and the following condition is detected:
·
No communication with ECM or hybrid vehicle control ECU continues for 3 seconds or more |
·
ECM ·
Hybrid vehicle control ECU ·
CAN communication system ·
Combination meter mirror ECU |
DTC stored | - |
| U0142 | Lost Communication with Body Control Module "B" | When IG voltage is 9.5 V or more and the following condition is detected:
·
No communication with main body ECU (multiplex network body ECU) continues for 3 seconds or more |
·
Main body ECU (multiplex network body ECU) ·
CAN communication system ·
Combination meter mirror ECU |
DTC stored | - |
| U0163 | Lost Communication with Navigation Control Module | When IG voltage is 9.5 V or more and the following condition is detected:
·
No communication with radio and display receiver assembly*1 or navigation receiver assembly*2 continues for 3 seconds or more |
·
Radio and display receiver assembly*1 ·
Navigation receiver assembly*2 ·
CAN communication system ·
Combination meter mirror ECU |
DTC stored | for Radio and Display Type or Navigation Receiver Type |
| U023A | Lost Communication with Front Camera Module | When IG voltage is 9.5 V or more and the following condition is detected:
·
No communication with forward recognition camera continues for 10 seconds or more |
·
Forward recognition camera ·
CAN communication system ·
Combination meter mirror ECU |
DTC stored | w/ Lane Departure Alert System |
| U1104 | Lost Communication with Driving Support ECU | When IG voltage is 9.5 V or more and the following condition is detected:
·
No communication with driving support ECU assembly continues for 10 seconds or more |
·
Driving support ECU assembly ·
CAN communication system ·
Combination meter mirror ECU |
DTC stored | w/ Pre-crash Safety System |
*1: for Radio and Display Type
*2: for Navigation Receiver Type
*3: w/ Lane Departure Alert System
*4: w/ Pre-crash Safety System
Check if CAN communication DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN communication DTCs are output. | A |
| CAN communication DTCs are not output. | B |
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING