Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM3210E _59 Vehicle Exterior _047514 WIPER / WASHER _0241724 WIPER AND WASHER SYSTEM D

WIPER / WASHER  WIPER AND WASHER SYSTEM  SYSTEM DESCRIPTION  


FRONT WIPER AND WASHER CONTROL FUNCTION


Control/Function Description
MIST function Operates the wipers in the LO setting when the windshield wiper switch assembly is held in the MIST position.
Auto operation (w/ Auto Wiper System) Operates the wipers as requested by the rain sensor when the windshield wiper switch assembly is set to the AUTO position.
Intermittent wiper operation control (w/o Auto Wiper System) Controls the delay of the wipers when the windshield wiper switch assembly is set to the INT position.
HINT:
·

The period of delay is controlled by the auto sensitivity adjustment switch on the windshield wiper switch assembly.

·

The period of delay changes in accordance with vehicle speed.



Washer cooperation
·

When the washer switch is operated for 0.5 seconds or more, the front wipers operate in the LO setting.

·

When the washer switch is released, the front wipers operate in the LO setting for 3 cycles.


NOTICE:

If the washer switch is operated for 40 seconds or more, operation of the washers is stopped to prevent burnout of the windshield washer motor, and the wipers return to the parked position.


Drip prevention wiper function 3 seconds after washer cooperation completes, operates the wipers for 1 cycle to remove any washer fluid that has dripped out.
HINT:

This function only operates when the vehicle is stationary and does not operate at a vehicle speed of 4 km/h (2 mph) or more.




REAR WIPER AND WASHER CONTROL FUNCTION


Control/Function Description
Intermittent wiper operation control Operates the rear wiper once every 12 seconds when the rear wiper switch is turned to the INT position.
Washer cooperation
·

When the rear washer switch is operated for 0.5 seconds or more, the rear wiper operates.

·

When the rear wiper operates for approximately 2.5 seconds after releasing the washer switch (rear).


NOTICE:

If the washer switch is operated for 40 seconds or more, operation of the washers is stopped to prevent burnout of the windshield washer motor, and the wiper return to the parked position.




OTHER FUNCTIONS


Control/Function Description
Washer fluid level low warning (w/ Level Warning Switch) Displays "Windshield Washer Fluid Low" on the multi-information display in the combination meter assembly when the washer fluid level is low.