Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM3210E _59 Vehicle Exterior _047514 WIPER / WASHER _0241724 WIPER AND WASHER SYSTEM U

WIPER / WASHER  WIPER AND WASHER SYSTEM  TERMINALS OF ECU  


CHECK WINDSHIELD WIPER RELAY ASSEMBLY (w/ Auto Wiper System)


E257545N08
3.396,0.177 3.792,0.417 0.396,0.24 3.469,0.219 4.073,0.49 0.604,0.271 10 false F43

a.

Disconnect the F43 windshield wiper relay assembly connector.

i.

Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.

Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
F43-2 (IG) - Body ground W - Body ground Power switch on (IG) signal (Power source circuit) Power switch on (IG) 11 to 14 V
Power switch off Below 1 V
F43-25 (W) - Body ground B - Body ground Front washer switch signal Front washer switch on Below 1 Ω
Front washer switch off 10 kΩ or higher
F43-8 (VR2) - F43-21 (VR1) L - GR Adjusting volume signal Windshield wiper switch adjusting ring* changed 0 to 231 Ω
F43-12 (E) - Body ground W-B - Body ground Body ground Always Below 1 Ω
F43-16 (WIG) - Body ground B - Body ground Power source signal Power switch on (IG) 11 to 14 V
Power switch off Below 1 V

HINT:

*: The rain sensor sensitivity can be adjusted by the windshield wiper switch adjusting ring.

If the result is not as specified, there may be a malfunction in the wire harness.




b.

Reconnect the F43 windshield wiper relay assembly connector.

i.

Measure the resistance according to the value(s) in the table below.

Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
F43-10 (+1) - Body ground G - Body ground Front wiper motor low speed signal Front wiper motor off Below 1 Ω

HINT:

If the result is not as specified, the windshield wiper relay assembly may be malfunctioning.



ii.

Measure the voltage and check for pulses according to the value(s) in the table below.

Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
F43-1 (+SM) - Body ground G - Body ground Front wiper motor position detection signal Front wiper motor in low or high operation Below 1 V ←→ 11 to 14V
Front wiper motor off Below 1 V
F43-3 (C1) - F43-5 (CO) V - B Front wiper switch AUTO signal Power switch on (IG), front wiper switch in AUTO Below 1 V
Power switch on (IG), front wiper switch off 11 to 14 V
F43-25 (W) - Body ground B - Body ground Front washer switch signal Power switch on (IG), front washer switch on Below 1 V
Power switch on (IG), front washer switch off 11 to 14 V
F43-10 (+1) - Body ground G - Body ground Front wiper motor low speed signal Front wiper motor in low operation 11 to 14 V
F43-11 (+2) - Body ground SB - Body ground Front wiper motor high speed signal Front wiper motor in high operation 11 to 14 V
Front wiper motor off Below 1 V
F43-14 (MPX1) - Body ground LG - Body ground Rain sensor signal Power switch on (IG) Pulse generation

HINT:

If the result is not as specified, the windshield wiper relay assembly may be malfunctioning.