Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM3210E _51 Engine / Hybrid System _047494 2ZR-FXE ENGINE CONTROL _0241780 CAMSHAFT OIL CONTROL VALVE G

2ZR-FXE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Put the engine in inspection mode (maintenance mode).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


e.

Start the engine.


f.

Inspect the camshaft timing oil control valve assembly.

i.

Enter the following menus: Powertrain / Engine / Active Test / Control the Intake VVT OCV Duty Ratio Bank 1 / Data List / Intake VVT Change Angle Bank 1.

Powertrain > Engine > Active Test
Active Test Display
Control the Intake VVT OCV Duty Ratio Bank 1
Data List Display
Intake VVT Change Angle Bank 1
50004 372 4 71


g.

Read the Data List while performing the Active Test with the engine idling.

Standard Condition:
GTS Operation Data List (Intake VVT Change Angle Bank 1)
-100% to 100% Varies by 70 DegFR or more


If the operation is not as specified, check the camshaft timing oil control valve assembly, wire harness and ECM.