Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SWITCH ASSEMBLY
RM3210E _59 Vehicle Exterior _047530 SLIDING ROOF / CONVERTIBLE _0241834 SLIDING ROOF SWITCH ASSEMBLY G

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF SWITCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)

a.
B431689C01
0.927,3.167 1.24,3.365 0.313,0.198 10 false *a
*a Component without harness connected
(Sliding Roof Switch (Map Light Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 - 11 UP switch pressed Below 100 Ω
4 - 11 UP switch not pressed 1 kΩ or higher
3 - 11 DOWN switch pressed Below 100 Ω
3 - 11 DOWN switch not pressed 1 kΩ or higher
6 - 11 OPEN switch pressed Below 100 Ω
6 - 11 OPEN switch not pressed 1 kΩ or higher
5 - 11 CLOSE switch pressed Below 100 Ω
5 - 11 CLOSE switch not pressed 1 kΩ or higher


If the result is not as specified, replace the sliding roof switch (map light assembly).