Home › Engine / Hybrid System › 2ZR-FXE FUEL › FUEL PUMP(w/ Canister Pump Module)
RM3210E _51 Engine / Hybrid System _047496 2ZR-FXE FUEL _0241960 FUEL PUMP(w/ Canister Pump Module) A

2ZR-FXE FUEL  FUEL PUMP(w/ Canister Pump Module)  REASSEMBLY  


PROCEDURE

Hide 23220A 1.INSTALL FUEL PUMP WITH FILTER ASSEMBLY

HINT:

Perform "Inspection After Repair" after replacing the fuel pump with filter assembly.

Click hereEngine / Hybrid System>2ZR-FXE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION


a.
A375513C02
2.396,0.969 2.573,0.792 2.573,0.792 2.719,0.792 false 2.406,1.135 2.656,1.135 false 2.781,0.719 3.094,0.875 0.313,0.156 10 false *1 2.719,1.073 3.031,1.229 0.313,0.156 10 false *2
*1 O-ring
*2 Fuel Pump Spacer


Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump with filter assembly.


b.

Connect the fuel pump harness connector to install the fuel pump harness to the fuel pump with filter assembly.


c.

Engage the 5 claws to install the fuel pump with filter assembly to the fuel filter.

NOTICE:
·

Make sure that the O-ring is not cut or pinched during the installation.

·

Engage the claws securely.

·

Do not remove the suction filter.




d.

Engage the 2 claws to install the No. 1 fuel suction support to the fuel filter.


e.

Install the 2 springs to the fuel suction plate shafts.


f.

Engage the 2 claws and install the fuel filter and fuel pump with filter assembly to the No. 1 fuel sub-tank.

NOTICE:

Do not apply excessive force to the tube or No. 1 fuel suction support.



g.
A374384

Engage the clamp and claw, and connect the fuel pump filter hose while aligning it with the installation position of the fuel sub-tank.


h.

Install a new E-ring to the fuel suction plate shaft.


i.

Connect the fuel pump harness connector.


j.

Engage the clamp to connect the fuel pump harness to the fuel suction plate sub-assembly.