77606
1.INSTALL NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY
Install the No. 1 fuel tank protector sub-assembly to the fuel tank assembly with the 3 clips.
77404
2.INSTALL FUEL TANK VENT HOSE SUB-ASSEMBLY
Engage the 2 clamps to install the fuel tank vent hose sub-assembly to the fuel tank assembly.
77209F
3.INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
Engage the 3 clamps to install the fuel tank main tube sub-assembly to the fuel tank assembly.
77100
4.INSTALL FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
Set the fuel tank assembly on an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Using the engine lifter, slowly raise the fuel tank assembly, and then install the fuel tank assembly with the 4 bolts.
Be careful not to drop the fuel tank assembly.
When installing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
77209F
5.CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Connect the fuel tank main tube sub-assembly to the fuel pipe.
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL SYSTEM>PRECAUTION
46430
6.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
Install the No. 3 parking brake cable assembly with the 2 bolts.
77213E
7.CONNECT FUEL TANK TO FILLER PIPE HOSE
Connect the fuel tank to filler pipe hose to the fuel tank assembly.
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL SYSTEM>PRECAUTION
77404
8.CONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY
Connect the fuel tank vent hose sub-assembly to the fuel tank solenoid main valve assembly.
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL SYSTEM>PRECAUTION
77641A
9.INSTALL NO. 1 FUEL TANK PROTECTOR
Install the No. 1 fuel tank protector to the fuel tank assembly with the 4 clips.
57628C
10.INSTALL REAR FLOOR SIDE MEMBER COVER LH
Install the rear floor side member cover LH with the clip (B).
Install the 3 bolts and clip (A).
58390
11.INSTALL NO. 1 FLOOR UNDER COVER ASSEMBLY
Install the No. 1 floor under cover assembly with the clip.
Install the 3 bolts.
17430
12.INSTALL TAIL EXHAUST PIPE ASSEMBLY
77020A
13.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
14.ADD FUEL