Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH
RM3210E _59 Vehicle Exterior _047514 WIPER / WASHER _0242030 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  REMOVAL  


PROCEDURE

Hide 45024 1.REMOVE LOWER STEERING COLUMN COVER SUB-ASSEMBLY

NOTICE:

Removing the lower steering column cover sub-assembly in the incorrect order will cause the parts to break.


a.

Release the tilt and telescopic lever and fully extend and lower the steering column assembly.


b.

Lock the tilt and telescopic lever.


c.
E337457

Turn the steering wheel assembly to the left and remove the screw.


d.
E337458

Turn the steering wheel assembly to the right and remove the screw.


e.
E337459C01
0.76,1.167 0.823,1.094 false
V100135

Push


Push the upper steering column cover and disengage the 2 claws as shown in the illustration.


f.
E337463

Disengage the 2 claws.


g.

Release the tilt and telescopic lever and fully extend and lift the steering column assembly.


h.

Lock the tilt and telescopic lever.


i.
E337518C01
0.875,4.063 0.958,4.063 false
V113146

Place Hand Here
V113147

Remove in this Direction


Pull the lower steering column cover sub-assembly toward the rear of the vehicle to disengage the claw and remove the lower steering column cover sub-assembly.


Hide 45286B 2.REMOVE UPPER STEERING COLUMN COVER

a.

Release the tilt and telescopic lever and fully extend and lower the steering column assembly.


b.

Lock the tilt and telescopic lever.


c.
E337466C01
1.417,0.531 1.417,0.417 false
V113147

Separate in this Direction


Disengage the claw to separate the upper steering column cover as shown in the illustration.


d.
E337465

Disengage the 2 claws and 4 clips to remove the upper steering column cover from the lower instrument cover sub-assembly.


Hide 84650 3.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

a.
E337468

Disconnect the 2 connectors.


b.
E337469C01
1.375,1.448 0.917,1.552 true 0.719,1.458 0.906,1.635 0.188,0.177 10 true *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

NOTICE:

If the claw is pulled with excessive force, it may break.


HINT:

Tape the screwdriver tip before use.